Many wireless systems are powered by special batteries that are recharged by Chargers or Docking Stations. In some cases, you place the entire device (like a bodypack or hand-held mic) into the charger, and in others, you need to remove the battery in order to recharge it. Also check out our Batteries & Chargers category.
The Shure SB904 lithium-ion battery pack delivers up to 12 hours of run-time on a full charge.
The Shure SBC10-100-E charging hub can be mains powered or run via the included micro-USB-B cable to recharge a single Shure SB900(A) battery.
The Sennheiser EW-D Charging Set includes an L 70 USB charger, two BA 70 rechargeable batteries, and an NT 5-20 UCW power supply complete with travel adapters.
The upgraded version of the PS21E, the Shure PS24E power supply is compatible with the SLX4E, SLX4LE, PG-Series, PGX-Series T3, T4V, T4G, T4N, T88 and LX88 wireless receivers.
The Shure SB903 rechargeable lithium-ion battery is fully compatible with all Shure SLX-D Series transmitters.
The Shure PS43E is here to replace the PS31E, PS40E and PS41E mains power adapters, and is compatible with receivers from the LX, UC, SC, ULX, SLX and PSM Series.
With the efficient Shure SBC203-PS charging hub, two SLX-D batteries can be recharged at the same time, whether it's an SD903 battery or an SLXD Series handheld transmitter.
This kit by Sennheiser consists of four BA 2015 rechargeable battery packs. These batteries are well suited for the handheld microphone, bodypack transmitters and wireless receivers from the Evolution Wireless G series.
Power supply for two or three L 2015 chargers.
The Sennheiser BA 70 Rechargeable Battery Pack is compatible with the SK and SKM-S receiver from the Sennheiser Evolution Wireless Digital Series and can be recharged with a Sennheiser L 70 USB charger (not included).
The Shure SBC80-903-E battery charger has enough slots to recharge eight Shure SB903 rechargeable batteries at a time, making it an indispensable accessory for extensive Shure SLX-D-based setups.
This single-slot charging station can be used to recharge a Shure SB904 rechargeable battery.
This rechargeable battery pack is suited for the EW series by Sennheiser. The BA 2015 battery can be charged with the L 2015 by Sennheiser.
Xvive's BCA58 Charging Case has been specially designed as an all-in-one solution for the A58 Guitar Wireless System. Indeed, in this black case you can store, charge and transport the wireless system.
This rechargeable battery for the JBL EON ONE MK2 portable line-array speaker system gives you six hours of performance.
The Sennheiser NT 12-5 CW+ power supply is compatible with the XSW G4 100 Series systems and since it comes with European, UK, USA, Korean, Australian and Chinese plug adapters, is fully tour-ready.
The L 2015 charger automatically charges two Sennheiser BA 2015 rechargeable batteries. The batteries can directly be charged in the charger itself or in their transmitter/receiver.
The Sennheiser NT1-1 is a power supply for a single L 2015 charger or ASA1 antenna splitter, for instance.
This adapter is compatible with the EW 300 G2 and EW 100 G2/G3 in-ear monitor systems by Sennheiser and is a handy replacement if your current adapter is broken or worn out.
The beltpacks from Sennheiser's D1 series can be powered via AA batteries, but the beltpacks' performance is improved if you use this BA 30 battery. Can be charged quickly with the separately available CHG-2 charger.
Upgrade your field kit with the Røde LB-1 rechargeable battery and set yourself up with up to 10 hours of additional battery life for your Performer TX-M2 and up to 100 hours of continuous power supply for VideoMic Pro+.
Ideal for content creators who're always on the move, this charging case for Shure's MoveMic system keeps your wireless microphone safely tucked up and charged at the same time.
If you do want to invest in the Wireless Go Gen 3 wireless tie-pick microphone, do yourself a favour, and pick up this Charging Case+ as well. A handy case for charging your Wireless Go III system.
The Sennheiser L 70 USB charger is compatible with the BA 70 battery pack of Sennheiser's Evolution Wireless Digital Series SK and SKM-S bodypack and handheld transmitters.
The Shure SB900C is a rechargeable Li-ion battery that can be used with several Shure products.
The Rode RS-1 is a charger for the TX-M2 wireless microphone and LB-1 battery. Also usable for Videomic Pro+.
If the battery of your XVive U5 camera microphone is dead, you can go right back on thanks to the U5C battery charger. In fact, 3 batteries are included.
The Sennheiser NT 12-35 CS 12 Volt power supply has been specially designed to power the active Sennheiser EW-D ASA Antenna Splitter.
The Sennheiser CHG 1-Kit-EU contains all the components you need to let your wireless transmitter or receiver from the Evolution Wireless series operate on a rechargeable BA2015 battery.
The Shure PS124 is an in-line power supply, equipped with non-lockable connectors for 4 wireless receivers (PG, PGX, PGXD, SLX) and/or PSM 200 transmitters.
The Sennheiser D1 system uses special battery packs, which can be recharged with this two-way CHG2 charger. It allows you to charge two batteries at the same time. Fit for the BA 10 and BA 30.
The Sennheiser CHG 70N-C is a charger with two bays for EW-DX transmitter batteries. You power the charger with the included adapter or via PoE. Control Cockpit software gives you control options and insight.
The Shure SBC10-903-PS charger accommodates a separately available SB903 battery for Shure's SLX-D series transmitters.
The compact Shure SBC210-E charges two SB900 batteries simultaneously. These battery packs are used for the P9RA and P10R wireless systems by Shure, among others.
Shure PS51E 5.5V DC power adapter for Shure chargers. This power adapter is equipped with a European safety plug and a plug adapter for Shure charging modules.
Sennheiser BA 40 rechargeable battery pack for SpeechLine DW table stands and transmitters, especially the SL 133 and the 153-S DW-3 table stands. This battery pack is included here as standard. It is therefore a spare part.
The Sennheiser CHG 2 W is a wireless charger that uses the Q1 charging stand to charge the batteries of Sennheiser SL table stands and boundary microphones.
The Sennheiser CHG 4N network charger allows you to fully charge the batteries of up to 4x SL DW handhelds and/or bodypacks within 2 hours. Each slot is equipped with LEDs that display the battery status of these devices.
The Shure SBC10-MicroB is suitable for charging the lithium-ion batteries of GLX-D wireless systems, such as in the beltpacks or handheld transmitters.
Shure SBC-DC DC voltage adapter for SB900-compatible bodypack transmitters/receivers such as the Shure P10R, P9Ra, QLXD1, ULXD1 and UR5.
The Shure SBC800-E 8-Up charges up to eight Shure SB900 batteries simultaneously. These rechargeable batteries are used for the P10R and P9RA in-ear monitor systems.
The Shure SBC200 Dual Docking is a recharging station for two SB900 batteries, body packs or transmitters. It is compatible with P9RA, P10R, ULXD1 and ULXD2 handheld/body pack transmitters. Used in combination with the SBC200-E.
The Shure SBC200-E is a charging station (with power supply) for two SB900 battery packs, belt packs or transmitters. It is compatible with body packs and transmitters from the P9RA, P10R, ULXD1 and ULXD2 series (among others).
If you are sick of having to buy new AA batteries for your SKM D1 transmitters, you should get your hands on the BA 10. This battery can easily be charged and is designed specifically for the D1 series.
Sennheiser's L 6000 is a practical charging station for bodypack transmitters or handheld transmitters from the Digital 6000 and Digital 9000 series. The 4 modules each feature two ports that accommodate battery packs.
The Sennheiser LM 6070 charging module is made for recharging two BA 70 batteries at once. It comes with four screws and is compatible with the L 6000 rack charger.
The Adapter Set NT 12-5 CW+ is a power supply for Sennheiser's EW-D EM receivers with a complete set of plug adapters for various countries.
