Top 10 best-selling Flight Case Hinges

This hinge with a fixed pin is made of zinc and has three pre-drilled holes with a diameter of 5.2 mm each. The distance between the outer holes is 57 mm and the hinge is 40 mm wide and 70 mm long.

This lift off hinge is made of steel and has a zinc colour. Equipped with four mounting holes of 5.2 mm each.

This zinc hinge with stay is equipped with eight pre-drilled holes with a diameter of 6.6 mm each. The hinge is 50 mm wide and 91.5 mm long.

Bearing outstanding design and build quality, the Penn Elcom PO-4270-32c stop hinge can be installed to give any DIY flight case or rack an ultra-secure finish.

The Adam Hall Hardware 2508 medium stop hinge has a chrome finish and stops at 95°. Ideal for various applications where safe and controlled opening is required.

Need a sturdy hinge with a built-in stay to finish a custom flight case? The Penn Elcom P1955S is perfect for heavier lids.

This hinge with fixed pin is made of zinc and is fitted with three pre-drilled holes with a diameter of 5.2 mm each. The distance between the two outer holes is 34 mm. The hinge is 40 mm wide and 50 mm long.

If you use this Penn Elcom D0554z lid stay in addition to your regular hinges, the lid of your flight case will stay open without falling backwards. This large edition lid stay has a zinc finish.

Thanks tot his lid stay the lid of your flight case will stay open but not fall backwards. This way, it’s easy to close your flight case again after using it.

This Penn Elcom zinc piano hinge has two zinc plates with a width of 20 mm. The distance between the pre-drilled holes is 51 mm.