Based on more than 21,240 customer reviews

Innox IVA Wind Wind-Up Stand

Discontinued, this product can no longer be ordered.

No alternatives found
Innox IVA Wind Wind-Up Stand
Product no: 9000-0005-6055 Bax Music Warranty: This product comes with a 3-year warranty.

General

The Innox IVA Wind is a wind-up stand, which means the vertical stand tube is not simply slid upwards, but lifted by means of a safe cogwheel pulley system. As such, the positioning of heavier speakers and lighting equipment becomes considerably easier. The IVA Wind folds up compactly and takes up little space during transport.

Technology of the IVA Wind

The IVA Wind is equipped with a practical pulley system, which makes it specifically suited for heavier loads. The stand base has a solid tripod construction with cross beams for additional stability. One of the legs can be extended, so you can always provide a level base for your equipment, even when the floor is uneven. The top of the stand has a 35 mm diameter, allowing for T4 bar, LED light system and truss adapter mounting. The IVA Wind is also often used to lift large speakers to their required height.

 

Tips or comments about this product

Please note:
- For heavy loads, we recommend that you extend the stand base to its full width for optimal stability.
- When using the stand, always make sure that the safety pins are in place and the locking screw is fully tightened for optimal stability.
- During operation of the pulley system, the top section must be unlocked and lifted first. After that, the second (middle) section can be unlocked and lifted.
- For use of the stand at maximum height, we recommend halving the maximum load capacity.
- This stand is a good alternative for the American DJ ST-132, which is no longer manufactured.

Specifications

Product features

Maximum height of stand 390 to 400 cm

Weight and dimensions including packaging

Weight (incl. packaging) 20,0 kg
Dimensions (incl. packaging) 180,0 x 33,0 x 24,0 cm

Product specifications

- Wind-up stand
- Practical pulley system lifts the stand to the desired height
- Stable construction
- Tripod base with stabilising cross beam connections
- 35 mm diameter top tube
- 1 leg can be extended for use on unlevel floors
- Handle can be flipped during transport for a compact construction
- Length stand legs: 1200 mm
- Minimum distance from stand leg to middle during use: 600 mm
- Maximum distance from stand leg to middle during use: 880 mm
- Minimum height fully unfolded in extended mode: 2050 mm
- Maximum height fully unfolded in extended mode: 3940 mm
- Pulley handle with adjustable screw ring, for right-angle attachment of hand grip
- T-bar: 1.22 m
- Extension part for one stand leg, with locking screw and safety pin
- Stand base adjustable in 3 steps
- Extension tube 1 (attached to stand base): 4 steps
- Extension tube 2 (attached to extension tube 1): 4 steps
- Maximum load capacity: 85 kg

A review can no longer be written about this item

Reviews from other countries

Translate all reviews into English

Innox IVA Wind Wind-Up Stand

Wrote the following about Innox IVA Wind Wind-Up Stand
Een absoluut zwaar gewicht statief van een imposant formaat, ingeklapt 1.80m hoog en zeker 20 kilo zwaar.
Let hier goed op bij de aanschaf i.v.m. opslag en transport.

Afwerking is op gemiddeld Chinees niveau maar best ok voor de prijs die je betaald.
Let wel goed op om vooraf even alle moeren en bouten na te lopen, sommige zitten half vast.
De safety pins moet je een halve slag draaien zodat ze in hun gleuf schieten, anders werken ze niet.

De zeer brede 3 poot voet en de dikke chromen hoofdbuis maken het tot een erg robuust en stabiel statief.
Het geheel werkt als een telescoopkraan wat je met de lier omhoog draait. De eerste buis uit de hoofdbuis komt tot ca. 3,00 meter en de tweede dunnere buis uit de eerste buis gaat daarna door naar ca. 4,00 meter.

Een prima statief voor een alleen 2-4 grotere moving heads, of 2 grotere moving heads en een lijn PAR's.
De breedte van de T-stand laat qua ruimte niet heel veel meer toe. Dan zou je deze moeten vervangen.

Voor recreatief gebruik een prima statief, voor professioneel en intensief gebruik heb ik mijn lichte twijfels.
Innox IVA Wind Wind-Up Stand

Wrote the following about Innox IVA Wind Wind-Up Stand
El pedido ha llegado en un estado muy mal los tubos estan oxidados y los agujeros de los pasadores no coinciden bien parece que han usado este producto ya es de segunda mano muy mal no estoy contento :(
Innox IVA Wind Wind-Up Stand

Wrote the following about Innox IVA Wind Wind-Up Stand
Een zeer degelijke wind-up statief met een robuuste uitstraling!
Door de dubbele statiefbuis en sterke staal kabel kan de wind-ip relatief veel belasting aan en hierdoor voor de middel zware werk goed gebruikt worden! En ook op ongelijke ondergrond is de statief goed inzetbaar doordat 1 poot verstelbaar is om zo een goede balans te creëeren. Elk verschuif/uitschuifbaar gedeelte is beveiligd met een soort klickpen waardoor elke verandering in hoogte of het verstellen van de poten veilig kan worden versteld en de klickpen elke verandering verzegeld. Ideaal in combinatie met trussysteem.
Innox IVA Wind Wind-Up Stand

Wrote the following about Innox IVA Wind Wind-Up Stand
pied stable mais de fabrication douteuse, les pièces soudées ne sont pas l'une en face de l'autre.

la tringlerie demande à être surveillée pendant les manoeuvres et surtout lors de la première utilisation.

pas de soucis à la montée mais peut coincer à la descente
Innox IVA Wind Wind-Up Stand

Wrote the following about Innox IVA Wind Wind-Up Stand
Had er 2 besteld. 1 ervan al met beschadiging door transport neem ik aan. Op t 1ste zicht zien het er degelijke statieven uit, maar alle pinnen komen bij trillingen los, het draaimechanisme op en neer trekt op niets. Ik durf hier zelfs nog nog geen 40kg aan te hangen uit schrik dat alles vanzelf naar beneden komt. Heb er telkens 1 theaterspot van 5kg ongeveer mee getakelt. Het naar beneden halen was een heel trek en sleur klus. Jammerlijke zaak, maar deze gaan terug retour!
Innox IVA Wind Wind-Up Stand

Wrote the following about Innox IVA Wind Wind-Up Stand
verschrikkelijk product. Veiligheidspennen kwamen niet overeen met de geboorde gaten en 1 van de hengels van de winch viel er meteen af. De algehele bouwkwaliteit is ronduit slecht. 4 stuks besteld en meteen weer retour gestuurd. Eigenlijk nog nooit zo'n slecht statief gezien :)



Retourservice trok ook op niets. 3 weken op een retour moeten wachten en nu zie ik dat ze ook maar 3 vd 4 statieven gecrediteerd hebben.
Innox IVA Wind Wind-Up Stand

Wrote the following about Innox IVA Wind Wind-Up Stand
Pas eu de chance avec ces pieds, livraison en deux fois, et à chaque fois défaut sur soudure cassée du boulon filetage réglage pied.

Le second poignée du treuil manquante. Dommage lourd et semble Robuste mais conséquence d un mauvais transport ou de l absence contrôle qualité en usine? ..je ne sais pas.

Seul point fort le sav et la sympathie bax shop.
Innox IVA Wind Wind-Up Stand

Wrote the following about Innox IVA Wind Wind-Up Stand
Eerst een statief ontvangen waarbij de veiligheidspennen niet overeen kwamen met de gaten. Zojuist mijn nieuw exemplaar mogen ontvangen en deze is wederom kapot het hijs mecha isme werkt niet. Ik raad deze dan ook niet aan. Tevens het retouren en ruilen is heel prettig verlopen
Innox IVA Wind Wind-Up Stand

Wrote the following about Innox IVA Wind Wind-Up Stand
zeer degelijke statief, hij staat stevig en is niet duur,
zeker goed te gebruiken voor truss.
Innox IVA Wind Wind-Up Stand

Wrote the following about Innox IVA Wind Wind-Up Stand
Een paar gig's mee gedaan en zeer degelijk statief. Zowel voor truss als voor frontlicht.

En natuurlijk ook weer een goede service door BAX!!
Description Type Language Extension
Innox IVA Wind Declaration of Conformity Unknown

Other products from Innox

Find all products of the brand Innox

Alternative products by other brands

Search all products in category Wind-up Lighting Stands

Related products from Innox

Find all products from the brand Innox in the category Wind-up Lighting Stands
Compare your gear (1/10)