Based on more than 21,240 customer reviews

Audio Technica ATM350W microphone with woodwind mounting system

no reviews yet

Discontinued, this product can no longer be ordered.

No alternatives found
Not sure if the Audio Technica ATM350W microphone with woodwind mounting system is for you? Do a Choice Check. Start Choice Checker
Audio Technica ATM350W microphone with woodwind mounting system
Product no: 9000-0030-1901

Product information

General

Audio Technica's ATM350W consists of the enhanced ATM350a condenser microphone and the AT8491W woodwind mounting system. The latter features a 12.7cm gooseneck for optimal positioning. The UniMount system allows you to use the microphone with a large number of different instruments, even though the ATM350W is especially developed for wind instruments. The condenser mic can handle a very high sound pressure level, making it suitable for instruments with broad dynamic ranges.

Focused audio thanks to cardioid pickup pattern

The ATM350a's audio remains focused and clear at all times thanks to its cardioid pickup pattern. Any sound from the sides or behind the mic are filtered out, resulting in a pure representation of the audio source. There is also an 80Hz high-pass filter on the microphone that filters out low frequencies and noise when activated. Finally, the gooseneck is made of a durable material that is both robust and flexible, allowing easy and optimal positioning in seconds.

Specifications

Product features

Connection type
XLR 3p
Microphone sensitivity (dBV/PA)
-49
Maximum SPL
150 dB - 159 dB
Maximum frequency
20 - 20.9 kHz
Minimum frequency
40 - 49 Hz
Polar pattern
Cardioid
Especially for
Wind instruments, double basses / cellos / violins, snare drums / toms / percussion instruments, pianos

Weight and dimensions including packaging

Weight
739 gr
Dimensions
31,5 x 15,0 x 8,5 cm

Product specifications

  • instrument microphone
  • capsule: condenser (permanently polarized)
  • pickup pattern: cardioid
  • frequency response: 40 - 20,000 Hz
  • high-pass filter: 80 Hz, 12 dB
  • sensitivity: -49 dB (3.5 mV) 1V @ 1 Pa
  • impedance: 200 ohms
  • max. sound pressure level (SPL): 159 dB, 1 kHz @ 1% THV
  • dynamic range: 130 dB, 1 kHz @ max. SPL
  • signal-to-noise ratio: 65 dB, 1 kHz @ 1 Pa
  • phantom power supply: 11 - 52V / 3.5 mA
  • switch: neutral, roll-off
  • mic weight: 14.5 g
  • power module weight: 90 g
  • microphone dimensions:
    • 37.8 mm (length)
    • max. body diameter: 12.2 mm
    • power module dimensions:
    • 92 mm (length)
    • 18.9 mm (diameter)
  • output connector: 3-pin male XLR
  • cable:
    • length: 4 m (permanently attached to microphone)
    • diameter: 3.2 mm
    • type: HIROSE HR10 (shielded)
  • box contents:
    • ATM350a cardioid condenser microphone
    • AT8543 power module
    • AT8491W woodwind mounting system
    • AT8490 UniMount 5-inch gooseneck
    • AT8468 violin clip
    • M36 protective carrying bag

Bax Music Warranty This product comes with a 3-year warranty, the styluses come with a manufacturing defects warranty.

Reviews (0)

A review can no longer be written about this item

There are no reviews for this product yet.

Videos

Downloads

Other products from Audio Technica

Find all products of the brand Audio Technica
Compare your gear (1/10)