Innox Basic Line Rack 4U-23 Double-Door Flight Case, 3U, 23cm

I bought an Innox Basic Line Rack 4U-23 Double-Door Flight Case, 3U, 23cm a year ago, and although it is a very basic flight case (you may have to do some modding) it does the job without adding too much weight to the Soundcraft Ui24R I bought it for.
I've just upgraded my PA and decided to buy another one for the new Midas stage box. It may seem strange to buy such a basic flight case for an expensive bit of kit, but the original one has provided sterling service and why spend more when you don't need to.

If you're going to buy one or more of these you need to be good at DIY to get them to work for you. I bought one because it was cheap, because I knew that would mean it would be relatively lightweight. I am 67 with arthritis, so heavy isn't good for me! It only need to survive being put in the back of my car, taken out at the venue then the same in reverse, so I don't need them to be bomb proof, if you need bomb proof look elsewhere and pay more. Issues are: 1) The handle is plastic held on by four 13mm screws so the case may well fall off at any moment leaving you just holding the handle, so you need to replace it with a decent metal handle held on with proper nuts and bolts or rivets. 2) The front rail system for holding the amps or whatever was designed by an idiot i) the nuts are not captive so can just spin when you try to tighten the bolts ii) the bolts are too short to reach the nuts so you need to put a strip of cardboard under the nuts to lift them high enough so the bolts can engage and be screwed into them iii) the bolt heads are too small so they just go through the fixing holes in the amps or whatever (in my case a pair of Crown XLSs), so you need some washers to prevent them falling through 3) the feet are right on the edge, so the slightest lateral movement and they will fall off the rack case below. This presumably has been done to transmit the load up the side walls, but trust me (I'm a material scientist and engineer) you can move them 3cm inboard without any problem. Bearing in mind you only have to sort all of this out once and then it's done, they are not a bad buy for less than £50, but if your DIY phobic they are not for you.