Sennheiser MZR 8000 adapter ring for MKH 8018. The microphone holder on some cameras is too big for the Sennheiser MKH 8018. This ring solves that nicely.
A handy connection cable for an electric guitar or bass to a Sennheiser evolution wireless bodypack transmitter, ideal as a spare or replacement.
This tube connector easily connects a vertical MZEF 8xxx bar to an MZE 8xxx extension tube – ideal for expanding your microphone setup.
Small frequency cap designed for the Sennheiser SL Headmic 1, in gold.
Large frequency cap for the SL Headmic 1, finished in a gold-coloured version.
The Sennheiser SL PASC 4 is a passive 4-way antenna splitter designed for the SpeechLine Digital Wireless series.
60 cm extension tube for the Sennheiser MKH 8030, ideal for demanding recording situations.
120 cm extension tube for the Sennheiser MKH 8030, ideal for professional microphone set-ups.
A specially designed foam windscreen for the Sennheiser MKH 8030, ideal for hassle-free recording in windy conditions.
This original Sennheiser cable is mostly used to connect antenna splitters to receivers. It has a length of 0.5 metres and is equipped with BNC connectors on both sides.
With the smart Sennheiser EW-D Power Distribution Cable, you can easily feed up to four EW-DX receivers power using just one NT 12-35 CS power supply.
The Sennheiser MKE 600 is the ideal windshield if you want to use your MKE 600 shotgun microphone outdoors. The combination of foam and fake fur reduces the wind noise perfectly.
Sennheiser HSP 4 boom (part 511713, beige)
The Sennheiser MZA 900 P is a phantom power adapter with which you can connect your 3.5mm mini-jack plug condenser microphone to a traditional XLR microphone input.
Replacement black steel grille for a Sennheiser MKE-2 microphone.
If the grille that came with your Sennheiser e835 vocal microphone has seen better days, simply swap it out for the compatible Sennheiser 577714 replacement grille and freshen up your mic.
It's safe to say the capsule of your Sennheiser e865 microphone needs to be properly shielded at all times, so make to sure to pop on this Sennheiser-made replacement grille if its original grille has been damaged or is simply nowhere to be found.
The Sennheiser MM 435 is a high-end dynamic capsule for your wireless handheld transmitter from the 2000, 6000, 9000 or evolution wireless G4 series. Minimum feedback, maximum definition.
Made for the Shure ME4N clip-on microphone, this windshield supports clean audio capture outdoors.
The Sennheiser MMD 835-1 black grille top is a replacement part for the MMD 835-1 BK transducer.
The MMD 42-1 microphone capsule by Sennheiser is modelled directly after the renowned MD 42 reporter mic. It's a dynamic, omnidirectional capsule and is suitable for the AVX, D1, Speechline, EW, 2000, 6000 and 9000 transmitters.
If your wireless Sennheiser system is suffering from interference in a more difficult environment, you can amplify the signal with 4 dB with this Sennheiser AD 1800 passive directional antenna to increase the range.
The HALF WAVE DIPOLE from Sennheiser is a set of 2 antennas with BNC connector. These antennas are suitable for connecting to an EW-D EM or EW-DX EM2 receiver.
Sennheiser's MZ 100 is an accessory set for ME 102, ME 104 or ME 105 and includes 2 sliding clips MZQ 102 in anthracite and grey, 2 microphone clips MZQ 02 in anthracite and nickel, 2 ZH 100 clips in anthracite and beige.
The Sennheiser MZA 900 P-4 is a phantom power adapter that allows you to connect your Sennheiser condenser microphone, equipped with a 3-pole lemo plug, to a traditional XLR microphone input.
Sennheiser's MZW 71 is a windshield made of foam that provides very good protection against wind and plop noise. This practical accessory is made especially for the MKH 70.
The Sennheiser MZF 8000 II filter module adds a low-cut filter and a PAD to your MKH 8000 Series microphone, which is never a bad thing when you're on working on a film set or recording sound effects.
The Sennheiser Profile Wireless Charging Bar has two functions. First, you can use it to charge your separately available Profile Wireless system but you can also use it to turn one of your transmitters into a handheld microphone.
If you prefer not to use clips to secure your Profile Wireless transmitter to clothing, the Sennheiser Profile Wireless Clip Magnet provides an outstanding alternative.
Need a new grille for your Sennheiser SKM XSW handheld microphone because the old one is dented or has gone missing entirely? No worries — just grab this Sennheiser Basket. Compatible with the XSW 1-825, XSW 1-835 and XSW 1-865.
Sennheiser MZS 80 shockmount for the MKH 80, MKH 800 and MKH 30 microphones. This shockmount serves as a spare part for the standard supplied product.
The Sennheiser MAS 1 is a robust microphone button that you can use in combination with the Sennheiser MAS 133 switch box for microphones! This button switches between different modes for your XLR microphone.
Sennheiser BA 40 rechargeable battery pack for SpeechLine DW table stands and transmitters, especially the SL 133 and the 153-S DW-3 table stands. This battery pack is included here as standard. It is therefore a spare part.
The Sennheiser CHG 2 W is a wireless charger that uses the Q1 charging stand to charge the batteries of Sennheiser SL table stands and boundary microphones.
Immediately freshen up your Sennheiser e935 vocal microphone with the Sennheiser 577728 replacement grille.
Optimise the performance of your Sennheiser HSP 4 headset microphone and counter wind and plosives during close-miking or when working with energetic performers with this tailor-made Sennheiser windshield.
Filters
Filters