Gator Cases GTSA-MIX12PU 12U Polythene Case for Mixers

Gator Cases GTSA-MIX12PU 12U Polythene Case for Mixers
Product no: 9000-0062-7900 Bax Music Warranty: This product comes with a lifetime manufacturing defects warranty.

General

The Gator Cases GTSA-MIX12PU polythene 12U case for mixers features a 12U rack profile. Using this case, you can be sure that your mixer will be excellently protected during transport. A plane trip, taking the car to a gig or walking to the rehearsal room: this case always offers optimal protection. In large part, this high level of protection is thanks to the polythene exterior. This is one of the most impact-resistant materials; by nature it is virtually indestructible. The angle of the rack profile is adjustable thanks to the handy pop-up system. So you can use your mixer straight from the case.

Tips or comments about this product

Note: The mixer pictured is for illustration purposes only and is not included.

Specifications

Product features

Sustainable product	not specified
Protection type	hard case

Weight and dimensions including packaging

Weight (incl. packaging)	8,3 kg
Dimensions (incl. packaging)	67,0 x 60,0 x 29,5 cm

Product specifications

Gator Cases GTSA-MIX12PU
case for mixers
material: polythene
12U rack profile
black powder-coated hardware & continuous valance
ergo-grip handle
red release trigger
threaded rack rails
padded wrist rest
pop-up system
TSA approved for air travel
solid construction
splash-proof
dimensions:
- length interior: 53.3 cm
- interior width: 48.3 cm
- interior height: 19.1 cm
- length exterior: 68.6 cm
- exterior width: 58.4 cm
- exterior height: 26.0 cm
weight: 7.7 kg

Write a review

Titch March 11, 2024

Wrote the following about Gator Cases GTSA-MIX12PU 12U Polythene Case for Mixers

Arrived from BAX with pop up frame jammed underneath the two right angled bracket that should act as travel stops. Plastic is so flimsy that lifting using handle adjacent to travel stops permits this to happen, when mixer is fitted and then it’s very difficult to release.

Only one handle on right hand side to lift or move case when in situ.

Right hand ratchet failed to release at first gig
Left Hand ratchet jammed solid at second gig – had to be removed to drop mixer
Lifting strap broke at third gig

I’ve replaced both ratchet stays myself for less than the return shipping cost under warranty – these are standard units not a patented design, however they are fitted incorrectly and without an essential component which is why they will never work properly and always fail to release or jam. I have also sorted out the travel stop and handle issues.

Do not buy this case it is utterly useless without four essential fundamental design changes.

I wish SKB still made their pop up case – it was brilliant and they had a lifetime warranty which they honoured in full.