RØDE NT5 Condenser Studio Microphone

polar pattern	cardioid
stereo	yes, matched pair
microphone accessories	microphone clip, windshield, bag / box
interchangable capsules	yes
Complete	~
Original packaging	~
Condition of product	~

RØDE NT5 Condenser Studio Microphone
Product no: MAF-102191 Bax Music Warranty: This product comes with a 10-year warranty after registration at warranty.rode.com/register

General

If you want to capture every last detail, then go for the Rode NT5 small-diaphragm condenser microphone. In addition to a focussed cardioid pickup pattern, this pencil mike features a half-inch gold-plated diaphragm plus a JFET preamp for low noise and a high output. Despite its high sensitivity, the NT5 can be used to record loud instruments since it can handle sound pressure levels of up to 143dB, which is just about as loud as a plane taking off. The Rode NT5 comes complete with a clip, a windshield and a pouch.

Tips or comments about this product

Please note: Rode microphones have an XLR pin (the grounding) that extends a little bit further than the others.
Visit the Rode Sound Booth to check out the sound of this microphone.

Specifications

Product features

Sustainable product	not specified
Microphone sensitivity (dBV/PA)	-38
Microphone impedance	100-149 ohms
Maximum SPL	140 dB - 149 dB
Maximum frequency	20 - 20.9 kHz
Minimum frequency	20 - 21 Hz
Low-cut filter	no
Pad switch	no
Polar pattern	cardioid
Stereo	no
Microphone accessories	microphone clip, windshield, bag / box
Interchangable capsules	no

Weight and dimensions including packaging

Weight (incl. packaging)	350 gr
Dimensions (incl. packaging)	27,0 x 13,0 x 5,0 cm

Product specifications

Rode NT5
acoustic principle: pressure gradient
polar pattern: cardioid
frequency range: 20Hz - 20kHz
output impedance: 100 Ohms
signal-to-noise ratio: 78dB SPL
max. SPL 143dB (at 1kHz, 1% THD in 1 kOhm load)
sensitivity: -38dB re 1 Volt/Pascal (6.3mV at 94dB SPL) +/- 2dB at 1kHz
weight: 101g
dimensions: 118 x 20 x 20mm

Write a review